More About Cables The DC power cables supplied with your Voodoo Lab Pedal Power 2 are suitable for most common pedal effects. If you need additional cables they are available directly from Voodoo Lab. If you need cables of a different length, with reversed polarity, or with a special connector, contact us and we can provide them for you.
Advertising
![]()
teries. This is mostly useful for transistor-based fuzz and distortion
circuits, as modern opamp designs are minimally affected by vari- ations in supply voltage. It is not recommended for digital pedals.
More About Cables
The DC power cables supplied with your Voodoo Lab Pedal Power 2
are suitable for most common pedal effects. If you need additional cables they are available directly from Digital Music. If you need cables of a different length, with reversed polarity, or with a special connector, contact us and we can provide them for you.
Operation
Using the above information, connect the DC power cables between
the Pedal Power outputs and the power jacks on your pedal effects. Now connect the AC power cord from the AC Power Input jack on the Pedal Power to a suitable AC outlet. The Pedal Power’s red LED power indicator should light telling you that it’s working properly.
Frequently Asked Questions
If you have any questions, this is the first place to look!
Why is the LED on my Boss pedal so dim?
Check to see if your Boss pedal is supposed to operate with
an ACA type adapter. It will say this either on a sticker near the power jack, or on the bottom plate. You need to operate this pedal at a higher voltage by setting the appropriate Voltage Selector DIP Switch on the bottom of the Pedal Power to the “OFF” position. See the section above “Boss Pedals”.
Can the Pedal Power fit in a rack?
The height of the Pedal Power was intentionally kept to 1-3/4
inches so that it can fit in one rack space. When we build pedal switching racks in (using Digital Music’s Ground
Advertising
Popular Brands
Popular manuals
Advertising
Control switching system), we usually mount the Pedal Power
along with the pedal effects on a sliding shelf.
What if my pedal uses reversed polarity (positive ground)?
Because the Pedal Power has each of its DC outputs isolated,
it doesn’t matter whether your pedals are negative or positive ground. What does matter is that the power jack has the cor- rect polarity. The barrel connectors provided are for center negative and the 3.5mm mini plugs are for tip positive. If your pedal is different from this, contact Digital Music to obtain the correct cable.
Doesn’t my pedal need a 200mA power supply?
Voodoo Lab Pedal Power 2 Plus Manual Francais
Not if it runs on a standard 9V battery. The adapter available
from the pedal’s manufacturer may be able to supply
up to 200 or 300mA, but pedal effects which will run on a
battery will not draw more than about 65mA.
Can I use the Pedal Power instead of the AC adapter for my
processor or MIDI pedal?
No. The Pedal Power is intended to run only pedal effects
which are normally powered by 9V batteries, so it will only provide a maximum of 100mA per output. You can plug the AC adapter supplied with your processor or MIDI pedal into the Pedal Power’s AC auxiliary outlet. Voodoo Lab Pedal Power 2 Plus Manual German
Can I power my pedal which requires 18V (uses two
9V batteries)? ![]() Voodoo Lab Pedal Power Digital
Yes. Because the Pedal Power’s outputs are individually iso-
lated, you can wire two of them in series for 18V. Be sure to observe proper polarity. Digital Music can provide you with a custom cable to do this.
Advertising
Popular Brands
Voodoo Lab Pedal Power 2 Power Supply Manual
Popular manuals
Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |